Use your 10-mm socket and ratchet to remove two (2) washer nuts from the inside of the small cubby hole under the radio and airbag switch. Set the washers aside. Remove two (2) 10-mm screws from the bezel below the steering column. Set the screws aside. Pull the bezel toward you releasing six (6) clips. On the passengers side, remove two (2) 10-mm screws on the lower bezel below the glove box. Set the screws aside. Pull toward you to release two (2) clips and a pin that is connected to the larger radio bezel. Remove the bezel that surrounds radio, climate control and instrument panel. Use the Dash Trim Panel tool in the upper right corner of the bezel releasing the first clip. Continue working the bezel loose to all the way to the left of the steering column for a total of twelve (12) clips. Tilt the bezel out just enough to gain access to the screw that is on the right side of the radio.
- No related posts